Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Flip the laptop upside down so that the bottom is facing up.
-
Identify the RAM tray on the bottom of the laptop.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the Phillips #0 screwdriver to remove the 9mm screw in the bottom left corner of the RAM tray covering.
-
Remove the RAM tray cover by prying up with a spudger.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Identify the Hard Drive tray to the left side of the laptop.
-
Remove screw with a #0 Philips screwdriver.
-
Lift up the Slot covering using a spunger.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the Phillips #0 screwdriver to remove the 9mm screws holding the back cover in place.
-
Remove the screws from the hard drive and remove it from the device.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Carefully remove the back shell from the device working your way around all the edges.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Removing the back shell of the computer and it will look like this.
-
The battery for the device is located at the bottom middle of the laptop at this orientation.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Locate the connector of the battery to the motherboard.
-
Using your fingers, slide out the connector.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Locate the SSD in the top right corner of the laptop.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the Phillips #0 screwdriver to remove the 3mm screw holding the SSD card in place.
-
Cancelar: No complete esta guía.
9 personas más completaron esta guía.