Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
With the plastic opening tool pry open the grey plastic siding on both sides of the tablet.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using a Phillips #00 screwdriver remove the 4.0 mm screws on the sides of the tablet.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Once the 4 screws have been removed use the plastic opening tool to pry open the device on the side of the device.
-
After prying open the case with the plastic opening tool carefully remove the case from the device and place the device face down on its screen.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using a Phillips #00 screwdriver remove the 4.0 mm screws holding the battery in place.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift the battery out of the device, and disconnect the cable attached to the motherboard by pulling it out to the side not lifting it up.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using the plastic opening tool gently lift up the charging component out of its slot in the case.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Continue to lift up the cord until it is free from the case and only attached to the motherboard.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the power component from the motherboard by pulling it out horizontally. Do not pull up on the cord only pull out
-
Cancelar: No complete esta guía.
3 personas más completaron esta guía.
Equipo
UMass Dartmouth, Team 5-5, Landers Spring 2016 Miembro de UMass Dartmouth, Team 5-5, Landers Spring 2016
UMASSD-LANDERS-S16S5G5
3 Miembros
6 Guías creadas
2 comentarios
Probably no need to REPLACE the jack. Just push the little indented tabs in a fraction of a millimeter and it will make good contact again. I just did this with mine and it works perfectly now after having been a royal PITA for over a year.
