Saltar al contenido principal

Introducción

Once your hard drive fails, it's pretty simple to replace! Just follow this guide to replace the hard drive in your device.

  1. Remove the one 4.3mm Phillips #1 screw holding the back cover on. Remove the one 4.3mm Phillips #1 screw holding the back cover on.
    • Remove the one 4.3mm Phillips #1 screw holding the back cover on.

  2. Remove the four 2.8mm Phillips #000 screws holding the drive onto the case.
    • Remove the four 2.8mm Phillips #000 screws holding the drive onto the case.

  3. Gently pull the foam protector away from the pin connectors
    • Gently pull the foam protector away from the pin connectors

  4. Gently pull the drive up and away to disconnect the hard drive from its seat Gently pull the drive up and away to disconnect the hard drive from its seat
    • Gently pull the drive up and away to disconnect the hard drive from its seat

  5. Fully removed hard drive, screws, and foam cover
    • Fully removed hard drive, screws, and foam cover

Conclusión

To reassemble your device, follow these instructions in reverse order.

Josh Rowell

Miembro Desde 10/10/17

101 Reputación

1 Guía escrita

Equipo

USF Tampa, Team S6-G5, Remmell Fall 2017 Miembro de USF Tampa, Team S6-G5, Remmell Fall 2017

USFT-REMMELL-F17S6G5

7 Miembros

8 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 4

Todo El Tiempo: 218