Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Flip your Chromebook over so the bottom is facing up.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the 6 mm Phillips #00 screw that holds the back cover on.
-
Carefully lift the cover off.
-
Place the cover and screw safely to the side for now.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using the spudger or your finger, slide the battery release slider and hold in place as shown.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two 3 mm Phillips #00 screws located on the WiFi card.
-
Pop the wires off the WiFi card.
-
Tilt the WiFi card up and remove it by pulling.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the fifteen 6 mm Phillips #00 screws holding on the plastic backing panel.
-
Remove the five 3 mm Phillips #00 screws holding on the plastic backing panel.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the opening tool to pull the tabs back for the ribbon cable of the Solid State Drive.
-
Gently pull the ribbon cable out.
-
Remove the Solid State Drive.
-
-
Este paso está sin traducir. Ayuda a traducirlo
Herramienta utilizada en este paso:Tweezers$4.99-
Use the opening tool to pull the tabs back for the ribbon cable located under the RAM board.
-
Gently pull the ribbon cable out from under the RAM board using the angled tweezers.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the opening tool to pry apart the seam around the outer perimeter of the back casing.
-
Pry apart the back casing from the keyboard housing.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the opening tool to pull back the tabs on the ribbon cable still connecting the keyboard and the back panel.
-
Use the angled tweezers to gently remove the ribbon cable.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a soldering iron to de-solder the nodes shown on the SD Card Reader. There will be 11 nodes above (see the wide red rectangle), and one node on each side (see two red squares).
-
Remove and replace the SD Card Reader.
-