Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the opening tool to open the back cover. The opening tool should fit under the cover if you place it above the power button.
-
Lift this side of the back cover once the opening tool is inside the device.
-
Use the opening tool and your hands to gradually work around the edges of the cover.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift the back cover off of the device with your hands.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the piece of black, thin tape that is attached to the circuit board closest to the power button.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the opening tool to lift the ZIF connector that is holding the ribbon cable in place.
-
Pull out the ribbon cable from the circuit board. This cable should have the word "Audio" on it.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the Phillips #000 screwdriver to remove the three 3 mm screws on the circuit board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Carefully remove the circuit board from the device. The power button is located on this piece.
-
Un comentario
I have broken ZIF connector to hold power ribbon cable,can i repair this or change board?