Introducción

You will have to remove several screws and a couple of cables on the bottom of the ZG5 to remove or replace the wireless card.

Partes

No se requieren partes.

Turn the netbook upside down with the battery at the top, away from you.
  • Turn the netbook upside down with the battery at the top, away from you.

Agregar Comentario

Unlock the battery by sliding the switch located near the left hinge to the left "unlocked" position.
  • Unlock the battery by sliding the switch located near the left hinge to the left "unlocked" position.

Agregar Comentario

  • Slide the latch located on the opposite hinge from the lock while pushing the battery up.

Agregar Comentario

  • Gently loosen the two Phillips #0 screws in the small panel that covers the wireless card.

    • These screws are built into the panel and aren't meant to be completely removed.

Agregar Comentario

  • Lift up the panel and remove it from the case.

Agregar Comentario

  • Disconnect the two antenna cables from the left side of the wireless card.

Agregar Comentario

  • Remove the single 3.9 mm Phillips #1 screw from the bottom left of the wireless card.

Agregar Comentario

  • Gently lift up the left side of the wireless card and slide the card out of its socket.

mi lap NO tiene wireless card

gustavo cordova - Contestar

Conclusión

To reassemble your device, follow these instructions in reverse order.

6 personas más completaron esta guía.

Doug Gallatin

Miembro Desde 05/10/10

5,754 Reputación

10 Guías creadas

Equipo

Cal Poly, Team 7-49, Amido Fall 2010 Miembro de Cal Poly, Team 7-49, Amido Fall 2010

CPSU-AMIDO-F10S7G49

5 Miembros

10 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 4

Últimos 30 Días: 45

Todo El Tiempo: 22,156