Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the twenty-five 6mm Phillips #0 screws from the bottom panel of the laptop.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using the plastic opening tool, lift up on the side opposite of the Ethernet connector.
-
With the plastic opening tool under the bottom panel, work your way around the perimeter until the panel separates.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two 6mm Phillips #0 screws from the battery.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the battery from the motherboard.
-
Pull the battery up and out of the laptop.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the four 3mm Phillips #0 screws from the hard drive.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a spudger to flip up the retaining flap on the hard drive ribbon cable ZIF socket.
-
Pull the ribbon cable out of the ZIF connector and remove the hard drive from the laptop.
-