Saltar al contenido principal

ASUS Q324UA-BHI7T17 Power & Volume Button PCB Board Replacement

Qué necesitas

  1. ASUS Q324UA-BHI7T17 Power & Volume Button PCB Board Replacement, Battery: paso 1, imagen 1 de 1
    • Remove all 10 Phillips screws on the backplate.

    • All 10 screws are 0.55 inches and 20 mm in diameter.

  2. ASUS Q324UA-BHI7T17 Power & Volume Button PCB Board Replacement: paso 2, imagen 1 de 2 ASUS Q324UA-BHI7T17 Power & Volume Button PCB Board Replacement: paso 2, imagen 2 de 2
    • Carefully remove the backplate using the plastic opening tool.

  3. ASUS Q324UA-BHI7T17 Power & Volume Button PCB Board Replacement: paso 3, imagen 1 de 1
    • Locate the battery near the bottom.

  4. ASUS Q324UA-BHI7T17 Power & Volume Button PCB Board Replacement: paso 4, imagen 1 de 1
    • Next, lift up the battery connector from the laptop in the upper left side of the battery, using tweezers or spudger.

    • Make sure to complete this step with caution, because if the battery is not unplugged, the motherboard may shock you.

  5. ASUS Q324UA-BHI7T17 Power & Volume Button PCB Board Replacement: paso 5, imagen 1 de 2 ASUS Q324UA-BHI7T17 Power & Volume Button PCB Board Replacement: paso 5, imagen 2 de 2
    • Remove the six screws holding in the battery with a Phillips #0 screwdriver.

    • Once battery is lifted out and removed, proper dispose of the old battery.

    • Each screw is 0.5 cm in length and 0.5 cm in diameter.

  6. ASUS Q324UA-BHI7T17 Power & Volume Button PCB Board Replacement, Power & Volume Button PCB Board: paso 6, imagen 1 de 1
    • Remove the screw holding the Power chip in place and remove it using a Phillips head #0 screw driver.

    • Screw length is 0.5 cm in length and 0.5 cm in diameter

  7. ASUS Q324UA-BHI7T17 Power & Volume Button PCB Board Replacement: paso 7, imagen 1 de 3 ASUS Q324UA-BHI7T17 Power & Volume Button PCB Board Replacement: paso 7, imagen 2 de 3 ASUS Q324UA-BHI7T17 Power & Volume Button PCB Board Replacement: paso 7, imagen 3 de 3
    • Locate the ribbon connector connecting the power chip to the mother board.

    • Simply lift up the black component and the ribbon connector should be released, then the power chip should pop out easily.

    • Discard of the old power chip properly.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Scott Santiago

Miembro Desde 10/17/17

534 Reputación

5 Guías creadas

Equipo

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 1

Todo El Tiempo: 638