Saltar al contenido principal

3DR Solo Leg Replacement

Qué necesitas

  1. 3DR Solo Leg Replacement, Propeller: paso 1, imagen 1 de 1
    • Grip the arm, which is located underneath the propeller, with one hand, and with your dominant hand grip the center of the propeller.

  2. 3DR Solo Leg Replacement: paso 2, imagen 1 de 1
    • Twist the propeller from the locked to unlocked position as indicated by the images of the lock.

    • You will need to twist in this direction for 2-3 full rotations before the propeller will detach.

  3. 3DR Solo Leg Replacement: paso 3, imagen 1 de 1
    • Lift the propeller off the motor.

    • To remove the silver-top propellers, repeat these steps, turning the propellers in the opposite direction of the black-top propellers.

  4. 3DR Solo Leg Replacement, Leg: paso 4, imagen 1 de 1
    • Place the controller on a flat surface with the battery side down.

  5. 3DR Solo Leg Replacement: paso 5, imagen 1 de 3 3DR Solo Leg Replacement: paso 5, imagen 2 de 3 3DR Solo Leg Replacement: paso 5, imagen 3 de 3
    • Locate the leg and remove the two 10mm screws that hold the leg in place.

  6. 3DR Solo Leg Replacement: paso 6, imagen 1 de 1
    • Gently pull the leg up to remove it from its position.

    • Leg should be connected by a black wire.

  7. 3DR Solo Leg Replacement: paso 7, imagen 1 de 3 3DR Solo Leg Replacement: paso 7, imagen 2 de 3 3DR Solo Leg Replacement: paso 7, imagen 3 de 3
    • Locate the rubber grip at the end of the leg and, with your thumb, peel it back and pull it off.

  8. 3DR Solo Leg Replacement: paso 8, imagen 1 de 2 3DR Solo Leg Replacement: paso 8, imagen 2 de 2
    • Leg type 1 will contain a 1mm screw at the base of the leg.

    • Unscrew the 1mm screw located at the end of the leg.

  9. 3DR Solo Leg Replacement: paso 9, imagen 1 de 1
    • Gently pull the black cord up to release it from the leg.

  10. 3DR Solo Leg Replacement: paso 10, imagen 1 de 3 3DR Solo Leg Replacement: paso 10, imagen 2 de 3 3DR Solo Leg Replacement: paso 10, imagen 3 de 3
    • Leg type 2 will contain the antenna wire.

    • Gently pull up on and remove the plastic covering labeled "solo antenna".

    • Locate the antenna wire and carefully pull up and remove it.

    • The antenna wire is flimsy so use caution upon removal.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Leia Harlow

Miembro Desde 09/11/17

101 Reputación

1 Guía escrita

Equipo

CSU Fullerton, Team S2-G3, Bruce Fall 2017 Miembro de CSU Fullerton, Team S2-G3, Bruce Fall 2017

CSUF-BRUCE-F17S2G3

4 Miembros

5 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 1

Ultimos 30 días: 2

Todo El Tiempo: 317