Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Open the spare tire compartment in the trunk of the vehicle by pulling up on the black tab.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Locate the manufacturer supplied jack and jack handle in the spare tire compartment; these will be needed for the replacement.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Place the jack approximately 2 feet behind the passenger wheel tire at the shown location. Finger tighten the jack until snug against the frame.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Place the jack handle in the jack to begin lifting the car.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using two hands, turn the jack handle clockwise and raise the car.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Raise the car until the jack stand can fit underneath the frame. Place the jack stand under the frame as close to the jack as possible.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lower the car onto the jack stand by turning the handle counterclockwise. Remove the jack once the load is taken off.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Once the jack stand is securely in place locate the engine oil drain plug. This is most accessible by crawling on your back from the front of the car.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using the 14mm socket wrench, loosen the drain plug by turning counterclockwise until you can turn the plug by hand.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Once the plug is slightly loose, place the oil drain pan underneath the plug, remembering to account for the arc of the stream when placing the oil pan.
-
Continue to loosen the plug until oil begins to flow.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Allow oil to drain freely until drops of oil are slowly coming from the drain. Then re-tighten the oil drain plug using the 14mm socket wrench.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Locate the oil filter. This is most accessible on your back from the front of the car. The filter should be about a foot closer to the front of the car from the oil drain plug.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using the 3/8 inch socket wrench with extension, loosen the oil filter by putting the extension in the square hole in the filter and turning counterclockwise.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Place the oil drain pan directly under the filter. Fully loosen the filter by hand until you are able to remove it from the vehicle.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the paper filter from the filter cartridge; this is disposable. Use the flathead screwdriver to pry the o-ring off the cartridge.
reset the trip OD so maintenance light will go off, turn the key on, set it to trip A, turn key off, hold down the set knob while turning the key back on, wait till all the dashes disappear and 0's will come up, realese the knob and go to trip B , push and hold down on knob again and it will set back to 0.
-
Cancelar: No complete esta guía.
5 personas más completaron esta guía.