2007 Honda Accord Bass Speakers Replacement

Introducción

I wanted more than anything to give my children a good Christmas so I bought my daughter new speakers for her car. Then in order to get me to install them I chose to create a fast fix guide. You will find comprehensive instructions here to install new speakers and amplifier into the trunk of a 2007 accord. It may seem daunting at first but take it one step at a time and remember anything can be overcome with hard work, a little know how, and a bunch of money.

Qué necesitas

Paso 1 Bass Speakers

2007 Honda Accord Bass Speakers Replacement, Bass Speakers: paso 1, imagen 1 de 3

2007 Honda Accord Bass Speakers Replacement, Bass Speakers: paso 1, imagen 2 de 3

2007 Honda Accord Bass Speakers Replacement, Bass Speakers: paso 1, imagen 3 de 3

Using plastic opening tools, remove the floor trim panel on the driver's side door.

Editar

Paso 2

2007 Honda Accord Bass Speakers Replacement: paso 2, imagen 3 de 3

Remove the shifter frame panel with the same opening tools.

Editar

Paso 3

2007 Honda Accord Bass Speakers Replacement: paso 3, imagen 3 de 3

Unclip the heated seats harnesses.
Remove the 12V power supply connection.

Editar

Paso 4

2007 Honda Accord Bass Speakers Replacement: paso 4, imagen 3 de 3

Remove the cubby space to access the head unit.

Editar

Paso 5

Remove the center climate vents with the opening tools.

Editar

Paso 6

2007 Honda Accord Bass Speakers Replacement: paso 6, imagen 3 de 3

Remove the head unit from the dash.

Editar

Paso 7

2007 Honda Accord Bass Speakers Replacement: paso 7, imagen 3 de 3

Attach the wiring harness into the amp by clipping it in.

Editar

Paso 8

2007 Honda Accord Bass Speakers Replacement: paso 8, imagen 3 de 3

Run the wires under the back seat and along the driver's side door sill (removed in step 1) to under the steering wheel.

Editar

Paso 9

2007 Honda Accord Bass Speakers Replacement: paso 9, imagen 3 de 3

Find a spot to drill a hole through the firewall under steering wheel area in the footwell.

Editar

Paso 10

2007 Honda Accord Bass Speakers Replacement: paso 10, imagen 3 de 3

Run the power and ground wires from the trunk through the door sill and through the firewall to the engine bay.

Editar

Paso 11

2007 Honda Accord Bass Speakers Replacement: paso 11, imagen 3 de 3

Now run the power wire where it will be out of the way.
Run the power wire (red) and the ground wire (green) to battery, connect red to positive and green ground to a clean piece of the car body.
Make sure to leave the power wire off until finished.

Editar

Paso 12

2007 Honda Accord Bass Speakers Replacement: paso 12, imagen 3 de 3

Remove the wiring harness from the back of the head unit.
Connect the four speaker wires and one remote wire to the harness as suggested in the owner's manual.

Editar