1999 - 2003 Acura TL Ignition Coil Replacement (1999, 2000, 2001, 2002, 2003)

Introducción

This is a step-by-step guide will show you how to replace the ignition coil of your 1999 - 2003 Acura TL. Though this is a guide to replace a single coil, it is highly recommended that all of the ignition coils are replaced once or the engine may start to misfire. By following this guide you can save yourself an expensive trip to the mechanic.

Before you begin, turn off the car and put it in park. If you have driven recently, wait for the engine to cool before starting the repair.

Qué necesitas

Paso 1 Ignition Coil

1999 - 2003 Acura TL Ignition Coil Replacement, Ignition Coil: paso 1, imagen 1 de 2

1999 - 2003 Acura TL Ignition Coil Replacement, Ignition Coil: paso 1, imagen 2 de 2

Open the driver side door of car.

Editar

Paso 2

Pull the hood latch below the steering wheel and near the door frame towards you to pop open the hood.

Editar

Paso 3

Lift the hood slightly to where your fingers can fit under the hood.
Reach your fingers under the hood to find the latch that is slightly right off the center.
Pull and hold the latch up while simultaneously lifting the hood all the way up until it stays stationary.
Be careful that the hood is lifted properly to avoid an accident.

Editar

Paso 4

1999 - 2003 Acura TL Ignition Coil Replacement: paso 4, imagen 3 de 3

Use a flathead screwdriver to remove one screw from each corner of the cover.

Editar

Paso 5

Pull the engine cover towards you to remove it.

Editar

Paso 6

1999 - 2003 Acura TL Ignition Coil Replacement: paso 6, imagen 3 de 3

Pinch the socket, attached to engine coil, and pull up to release.
With an Allen key, loosen the screw holding the coil by turning counterclockwise.
Make sure to avoid exposed wires.