Repara tus cosas Comunidad Tienda

1999-2004 Jeep Grand Cherokee Power Steering Pressure Hose Replacement

Introducción

Here is a 2000 Jeep Grand Cherokee with a leaky power steering pressure line. The part is readily available at places like Autozone and many others. Replacement cost for the hose was $27. Not a very difficult job and it only requires a few hand tools.

Qué necesitas

  1. 1999-2004 Jeep Grand Cherokee Power Steering Pressure Hose Replacement, Power Steering Pressure Hose: paso 1, imagen 1 de 3 1999-2004 Jeep Grand Cherokee Power Steering Pressure Hose Replacement, Power Steering Pressure Hose: paso 1, imagen 2 de 3 1999-2004 Jeep Grand Cherokee Power Steering Pressure Hose Replacement, Power Steering Pressure Hose: paso 1, imagen 3 de 3

    • Here is a view of the power steering pump. It is located on the front left side in the engine compartment. Visible fresh oil stains on the fan shroud and other parts.

    • Most sludge was found at the pressure line connection

    • The leak is on top of the flare nut where the pipe enters the pump.

    Editar

  2. 1999-2004 Jeep Grand Cherokee Power Steering Pressure Hose Replacement: paso 2, imagen 1 de 3 1999-2004 Jeep Grand Cherokee Power Steering Pressure Hose Replacement: paso 2, imagen 2 de 3 1999-2004 Jeep Grand Cherokee Power Steering Pressure Hose Replacement: paso 2, imagen 3 de 3

    • To remove the hoses from the power steering pump, the air cleaner housing has to be removed. Remove the four clips on the air filter cover

    • Remove the air filter

    • Loosen the clamps from the air intake duct to remove the air cleaner cover from the engine.

    Editar

  3. 1999-2004 Jeep Grand Cherokee Power Steering Pressure Hose Replacement: paso 3, imagen 1 de 3 1999-2004 Jeep Grand Cherokee Power Steering Pressure Hose Replacement: paso 3, imagen 2 de 3 1999-2004 Jeep Grand Cherokee Power Steering Pressure Hose Replacement: paso 3, imagen 3 de 3

    • Here is the complete housing. There are three 13mm hex head mounting bolts for the air cleaner housing. One on the front left

    • one on the rear left

    • and the last one is difficult to find on the front right.

    Editar

  5. 1999-2004 Jeep Grand Cherokee Power Steering Pressure Hose Replacement: paso 4, imagen 1 de 3 1999-2004 Jeep Grand Cherokee Power Steering Pressure Hose Replacement: paso 4, imagen 2 de 3 1999-2004 Jeep Grand Cherokee Power Steering Pressure Hose Replacement: paso 4, imagen 3 de 3

    • All three bolts have lock nuts that can be accessed from the driver side front wheel well

    • Use a socket wrench or similar tool to loosen the bolts, then remove the nuts in the wheel well.

    • All three bolts and nuts are identical

    Editar

  6. 1999-2004 Jeep Grand Cherokee Power Steering Pressure Hose Replacement: paso 5, imagen 1 de 3 1999-2004 Jeep Grand Cherokee Power Steering Pressure Hose Replacement: paso 5, imagen 2 de 3 1999-2004 Jeep Grand Cherokee Power Steering Pressure Hose Replacement: paso 5, imagen 3 de 3

    • With the three bolts remove the air filter housing can simply removed. This gives full access to the power steering gear and hoses.

    • New line.

    • Use a 16mm x 18mm flare nut wrench. It will be safer than an open end wrench since it provides a better grip. This will prevent any damage to the flare nut on the hose.

    • Disconnect the hose on the power steering pump by loosing the flare nut in a counter clockwise rotation

    Editar

  7. 1999-2004 Jeep Grand Cherokee Power Steering Pressure Hose Replacement: paso 6, imagen 1 de 3 1999-2004 Jeep Grand Cherokee Power Steering Pressure Hose Replacement: paso 6, imagen 2 de 3 1999-2004 Jeep Grand Cherokee Power Steering Pressure Hose Replacement: paso 6, imagen 3 de 3

    • Disconnect the hose on the power steering gear by loosing the flare nut in a counter clockwise rotation

    • Once both ends are disconnected, remove the hose from the vehicle.

    • New line.

    • Install the supplied O-rings on either side of the new hose.

    Editar

  8. 1999-2004 Jeep Grand Cherokee Power Steering Pressure Hose Replacement: paso 7, imagen 1 de 1

    • Install new power steering pressure hose.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

16 personas más completaron esta guía.

Autor

con 4 otros colaboradores

oldturkey03

Miembro Desde 09/29/10

782,052 Reputación

119 Guías creadas

Insignias: 54

+ 51 más insignias

Equipo

Global Fixers Miembro de Global Fixers

Community

33 Miembros

537 Guías creadas

9 comentarios

This was so helpful! I have this exact issue with my power steering and this guide is going to make the job very easy! Thanks for posting this it really helped a lot!

Hadley Hofreiter - Contestar

Doing this job today thanks for making this! I didn't know I would need a flare nut wrench and luckily found one pretty cheap

Albert Einstein - Contestar

After topping up the steering fluid, the system can be bled again by turning the wheels from left lock to right lock a few times. Much easier when both wheels are off the ground.

Andries Holtzhausen - Contestar

Does the fluid not need to be drained out before removing the line?

Dave - Contestar

@dave7777 nope. Place a rag under the hose before you take it off so it does not leave to much of a mess. Check the fluid after.

oldturkey03 - Contestar

Gracias por la ayuda me gusto

Luis - Contestar

made my job much easier with your insite, thank you. no more leak!

burritobob99 - Contestar

THANK YOU! This has given me the courage to tackle this project.

Gary Saylor - Contestar

Will this work on a 2005 Jeep Grand Cherokee as well? The pump set up kinda looks the

masonsvilla - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 2

Ultimos 7 días: 39

Ultimos 30 días: 169

Todo El Tiempo: 42,790