Introducción
Use this guide to replace fogged or damaged tail lights in your '98-'02 Honda Accord.
Qué necesitas
-
-
Open the trunk using your key in the trunk key slot or by using the lever under the driver's console.
-
-
-
Remove the small plastic screw along the vertical edge of the trunk entrance using a flathead screwdriver.
-
Carefully peel back the trunk liner from around the edge of trunk opening by the light.
-
Locate the two panel tail light connectors located between the liner and the panel tail light assembly.
-
-
-
-
Locate the light bulb sockets in the trunk lid, located on the back side of the trunk tail lights.
-
Turn the light bulb sockets counterclockwise and remove them from their holes.
-
-
-
Remove the connector at the bottom of the panel tail light assembly.
-
Locate the three 8 mm nuts holding the panel tail light assembly to the car and use an 8 mm socket wrench or box end wrench to remove the them.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Cancelar: No complete esta guía.
3 personas más completaron esta guía.
4 comentarios
My tail lights, brake lights stay on even after I have turn the key off and pulled it out of the keyhole. Is there a part that might be broken that could repair this. Any comments I would appreciate them. Thanks oh I did find little pieces on the floor and wondered what that part might be maybe under the drivers side where the spring is
I have to take the cable off the battery or it goes dead. And the little part on the floor was kind of like a plastic washer with a little pointed top on it.
Thanks Nathan. The part was broken into pieces. There is a little spring underneath the steering and, back in a little bit that I wondered if it broke off from that, which would make the break stay on.