Introducción

Use this guide to replace your 4-cylinder Honda Accord's distributor cap. This specific guide was created for a non-VTEC F23A5 engine, but other 4-cylinder Honda engines will be similar enough to follow the same basic steps

  1. Before disconnecting the spark plug wires, be sure to trace their orientation from the individual cylinders back to the distributor cap.
    • Before disconnecting the spark plug wires, be sure to trace their orientation from the individual cylinders back to the distributor cap.

    • The cylinders are ordered from left to right when viewing the engine from the front of the car, with cylinder #1 being closest to the passenger side of the vehicle.

    • Mark the order of the spark plug wires on the new distributor cap with a silver sharpie marker -- it will make reinstallation much easier.

    Agregar Comentario

  2. Disconnect the four spark plug wires from the distributor cap by pulling their connectors straight away from the sockets on the distributor cap.
    • Disconnect the four spark plug wires from the distributor cap by pulling their connectors straight away from the sockets on the distributor cap.

    • It may be helpful to slightly twist the wires as you pull them.

    Agregar Comentario

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Use a 1/4" drive, 8 mm deep socket to remove the three hex bolts securing the distributor cap to the engine.

    • The position of the third bolt is not visible in the second picture.

    Agregar Comentario

    • Pull the distributor cap away from the engine and set it aside.

    Agregar Comentario

    • Use a dental pick or a small screwdriver to gently remove the D-shaped o-ring around the distributor cap flange.

    • Install a new o-ring in the seal recess, making sure that it is sitting flush against the flange.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

7 personas más completaron esta guía.

I need to do this procedure. Have never done this in years. Next time I will change my wires, plugs and now my distributor cap.

Thurman - Contestar

Where can I find the part number?

lawendellr - Contestar

what about 6 cylinder

ssingam75 - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 16

Últimos 7 Días: 103

Últimos 30 Días: 405

Todo El Tiempo: 51,927