Saltar al contenido principal

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

1997-2003 Chevrolet Malibu Tail Lights Replacement

Qué necesitas

  1. 1997-2003 Chevrolet Malibu Tail Lights Replacement, Tail Lights: paso 1, imagen 1 de 1
    • Locate the plastic casing that holds the trunk liner in place, directly behind the tail light.

    • Unscrew the plastic casings.

  2. 1997-2003 Chevrolet Malibu Tail Lights Replacement: paso 2, imagen 1 de 1
    • Make sure to put some pressure on the tail light itself so it does not fall out when you unscrew it.

    • Unscrew the three plastic wing nuts located behind the tail lights.

  3. 1997-2003 Chevrolet Malibu Tail Lights Replacement: paso 3, imagen 1 de 1
    • When the tail light assembly comes loose, do not fully remove it because it may damage the connected wires.

    • Carefully pull the tail light away from the car to expose the connected wires.

  4. 1997-2003 Chevrolet Malibu Tail Lights Replacement: paso 4, imagen 1 de 3 1997-2003 Chevrolet Malibu Tail Lights Replacement: paso 4, imagen 2 de 3 1997-2003 Chevrolet Malibu Tail Lights Replacement: paso 4, imagen 3 de 3
    • Unclip the rear panel of the tail light assembly. There are two clips on the top and two on the bottom.

    • Remove the rear panel from the rest of the assembly.

  5. 1997-2003 Chevrolet Malibu Tail Lights Replacement: paso 5, imagen 1 de 1
    • Do not pull on the bulb, handle it gently because it is fragile.

    • Grab the plastic base of the bulb and gently wiggle it free.

  6. 1997-2003 Chevrolet Malibu Tail Lights Replacement: paso 6, imagen 1 de 1
    • When handling the new bulbs, avoid touching the glass as much as possible because this can reduce the life of the bulb.

    • Gently push the new bulb into the plastic housing.

  7. 1997-2003 Chevrolet Malibu Tail Lights Replacement: paso 7, imagen 1 de 1
    • After putting the new bulbs in, turn the desired lights on to check that the newly installed bulbs work correctly.

    • These bulbs have different functions including blinkers, brake lights, hazard lights, and back-up lights. They will only turn on when the necessary signal is sent.

Conclusión

To reassemble your device, follow these instructions in reverse order.

4 personas más completaron esta guía.

Sank Yang

Miembro Desde 10/03/12

484 Reputación

5 Guías creadas

Equipo

Cal Poly, Team 9-15, Amido Fall 2012 Miembro de Cal Poly, Team 9-15, Amido Fall 2012

CPSU-AMIDO-F12S9G15

4 Miembros

5 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 3

Ultimos 7 días: 11

Ultimos 30 días: 42

Todo El Tiempo: 19,352