Repara tus cosas Comunidad Tienda

1992-1999 BMW 3 Series Driver Side Airbag Replacement

Introducción

Use this guide to replace the driver side airbag in your BMW E36. This procedure was done on a US 1997 M3 with the four spoke steering wheel.

Qué necesitas

    • This step is not necessary, but it made it easier for me to get at the steering column trim mounting screw. Feel free to skip this if you'd like.

    • Remove the two screws securing the upper edge of the knee bolster.

    • Pull the upper edge down to give access to the underside of the steering wheel.

    Traducir

    • Remove the lower steering column trim mounting screw.

    • Remove the lower steering column trim.

    Traducir

    • Make sure that the battery has been disconnected for at least 30 minutes before continuing further to ensure that the airbag light does not come on.

    • Disconnect the orange SRS connector.

    Traducir

    • Completely loosen the two T30 Torx screws behind the steering wheel while supporting the airbag unit from the front.

    • Make sure to support the airbag to prevent it from falling out.

    Traducir

    • Lift the airbag unit up and away from the steering wheel.

    • Disconnect the orange harness connector from the rear of the airbag unit.

    • The airbag should now be free to be removed.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

Autor

con 1 otro colaborador

Geoff Wacker

Miembro Desde 09/30/13

89,934 Reputación

89 Guías creadas

Insignias: 44

+ 41 más insignias

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 2

Ultimos 7 días: 4

Ultimos 30 días: 15

Todo El Tiempo: 550