Saltar al contenido principal

1986-1993 Volvo 240 Distributor Cap Replacement

Qué necesitas

  1. 1986-1993 Volvo 240 Distributor Cap Replacement, Distributor Cap: paso 1, imagen 1 de 2 1986-1993 Volvo 240 Distributor Cap Replacement, Distributor Cap: paso 1, imagen 2 de 2
    • The distributor cap is located next to the engine and has all of the spark plug wires connecting to it.

    • Pull straight up on the ignition coil wire in the center of the distributor cap to disconnect it.

  2. 1986-1993 Volvo 240 Distributor Cap Replacement: paso 2, imagen 1 de 3 1986-1993 Volvo 240 Distributor Cap Replacement: paso 2, imagen 2 de 3 1986-1993 Volvo 240 Distributor Cap Replacement: paso 2, imagen 3 de 3
    • Connect the spark plug wires to the new distributor cap one at a time. Mixing up the order will result in the engine not firing properly or at all.

    • Pull straight up on the boot of the first spark plug wire to disconnect it from the distributor cap.

    • Be sure to pull on the boot and not the wire itself. Spark plug wires are quite fragile and may break easily.

  3. 1986-1993 Volvo 240 Distributor Cap Replacement: paso 3, imagen 1 de 3 1986-1993 Volvo 240 Distributor Cap Replacement: paso 3, imagen 2 de 3 1986-1993 Volvo 240 Distributor Cap Replacement: paso 3, imagen 3 de 3
    • Install the spark plug wire onto the new distributor cap and make sure it is seated properly.

    • Continue to transfer each spark plug wire to the new distributor cap, maintaining the same arrangement of wires on the cap.

    • Once all of the spark plug wires have been installed on the new distributor cap, set the cap aside.

  4. 1986-1993 Volvo 240 Distributor Cap Replacement: paso 4, imagen 1 de 2 1986-1993 Volvo 240 Distributor Cap Replacement: paso 4, imagen 2 de 2
    • Use a flathead screwdriver to release the clip securing the distributor cap.

    • Only one side of the distributor cap has a spot for the clip to rest. The new cap must be installed in the same orientation.

    • Remove the old distributor cap.

    • When installing the new distributor cap, don't forget to reconnect the center ignition coil wire.

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

David Hodson

Miembro Desde 04/13/10

150,352 Reputación

127 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 2

Ultimos 30 días: 18

Todo El Tiempo: 6,533