Introducción
Microsoft has launched a new version of its official Xbox One Wireless Controller. It has a 3.5mm stereo headset jack, which will allow most third-party gaming headsets to directly connect to the controller for the first time.
Qué necesitas
-
-
Covert Forces model - Bowie 'Changes' look.
-
New 3.5mm jack socket next to expansion port.
-
-
-
Remove battery cover and battery
-
Remove side panels using spudger
-
Expose T9 security screw under label
-
Remove 5 x T9 security screws from chassis
-
Remove top and bottom covers
-
-
-
-
Tape down the rumbler motors to prevent them from falling out.
-
-
-
Remove 2 x T6 security screws on bottom PCB
-
De-solder rumble pack and trigger wiring
-
-
-
Thar she blows! DA7212
-
Dialog Semiconductor CODEC with Class G HP AMP and Class AB speaker driver.
-
CODEC sits next to contact pads for 3.5mm jack socket
-
15 comentarios
Is it possible to show the other board? Was thinking of doing a scuf-style mod to one of these... Thanks
Was asking this because the boards are different to the older controller. I have PCB prints of the old one, but not the new one. Thanks.
Can you point me where to get schematics that you have?
Anybody know where I can get the new style bumpers for this style of controller? Any help would be greatly appreciated.
The guy I buy from on ebay said they would be available at the end of January
