Saltar al contenido principal

Herramientas Destacadas en este Teardown

Este desmontaje no es una guía de reparación. Para reparar tu Wireless Bluetooth Water Dancing Speakers (SBT626) from Sharper Image, utiliza nuestros manuales de servicio .

  1. Teardown of Water Dancing Speaker
    • Teardown of Water Dancing Speaker

  2. Remove 4 screws from rear of speaker Peel back the rear half of the shell Remove the Water/Pump Chamber
    • Remove 4 screws from rear of speaker

    • Peel back the rear half of the shell

    • Remove the Water/Pump Chamber

  3. Remove 2 screws that hold the logic circuit in place Carefully pull the logic board up,  out of the plastic slot Carefully pull the logic board up,  out of the plastic slot
    • Remove 2 screws that hold the logic circuit in place

    • Carefully pull the logic board up, out of the plastic slot

  4. Carefully pull the Lithium Ion Battery out of the plastic slot If glue is holding battery in place, slowly peel the glue off the battery.
    • Carefully pull the Lithium Ion Battery out of the plastic slot

    • If glue is holding battery in place, slowly peel the glue off the battery.

  5. Remove the 3 screws holding the speaker Remove the speaker from the plastic shell
    • Remove the 3 screws holding the speaker

    • Remove the speaker from the plastic shell

  6. Disconnect the battery connector from the logic board Disconnect the motor connector from the logic board
    • Disconnect the battery connector from the logic board

    • Disconnect the motor connector from the logic board

  7. Disconnect the speaker connector from the logic board Disconnect the LED connector from the logic board
    • Disconnect the speaker connector from the logic board

    • Disconnect the LED connector from the logic board

  8. Remove the 2 screws holding the motor mount on the water/pump chamber Remove the motor mount from the water/pump chamber Remove the 2 screws holding the LED board on the water/pump.
    • Remove the 2 screws holding the motor mount on the water/pump chamber

    • Remove the motor mount from the water/pump chamber

    • Remove the 2 screws holding the LED board on the water/pump.

    • Remove the LED board from the water/pump

  9. Teardown Finished
    • Teardown Finished

    • For Reassembly: Follow Guide in Reverse

Kyle Trambley

Miembro Desde 06/10/16

284 Reputación

1 Guía escrita

Equipo

Cal Poly, Team 15-7, Livingston Fall 2016 Miembro de Cal Poly, Team 15-7, Livingston Fall 2016

CPSU-LIVINGSTON-F16S15G7

4 Miembros

6 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 12

Todo El Tiempo: 982