Introducción

The following tear down provides a step by step guide to completely disassemble a Palm Tungsten E.

Este desmontaje no es una guía de reparación. Para reparar tu Tungsten E, utiliza nuestros manuales de servicio .

  1. Remove stylus and SD card. Using T-5 torx driver, remove 4 back panel screws.
    • Remove stylus and SD card.

    • Using T-5 torx driver, remove 4 back panel screws.

    • The screws are small and can be lost easily. Be sure to place them in a secure area.

  2. Begin to remove back cover by inserting the plastic opening tool under the usb and power input slots. Continue by sliding the plastic opener to the right at the markers shown until the cover releases. Continue by sliding the plastic opener to the right at the markers shown until the cover releases.
    • Begin to remove back cover by inserting the plastic opening tool under the usb and power input slots.

    • Continue by sliding the plastic opener to the right at the markers shown until the cover releases.

  3. ¡Envío gratuito para todos los pedidos de más de USD100.00 o que contengan un Pro Tech Toolkit!

    Visita Nuestra Tienda
  4. Your device may not have a screen protector. If not, you do not need to complete step three. Please move on to step four. Remove screen protector by lifting hinge out of plastic housing.
    • Your device may not have a screen protector. If not, you do not need to complete step three. Please move on to step four.

    • Remove screen protector by lifting hinge out of plastic housing.

    • Remove top cover by gently pulling away from the device with plastic tool

  5. Carefully remove motherboard from the standoffs without damaging the LCD flex connector. Using spudger( the black pencil-like tool shown in picture two), unlock both sides of the flex connector block (shown in the purple boxes in picture two) by pushing down.
    • Carefully remove motherboard from the standoffs without damaging the LCD flex connector.

    • Using spudger( the black pencil-like tool shown in picture two), unlock both sides of the flex connector block (shown in the purple boxes in picture two) by pushing down.

    • Remove motherboard completely.

    • Metal washers may pop out of the device during this step

  6. Remove buttons using fingers. Gently flex frame to release screen from plastic frame. Lift out screen.
    • Remove buttons using fingers.

    • Gently flex frame to release screen from plastic frame.

    • Lift out screen.

  7. Congratulations! You have successfully taken apart a Palm Tungsten E.
    • Congratulations! You have successfully taken apart a Palm Tungsten E.

Kevin Hom

Miembro Desde 21/01/10

88 Reputación

2 Guías creadas

Equipo

Cal Poly, Team 13-22, Maness Winter 2010 Miembro de Cal Poly, Team 13-22, Maness Winter 2010

CPSU-MANESS-W10S13G22

4 Miembros

4 Guías creadas

How does one unplug the battery?

dlcatftwin - Contestar

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 2

Últimos 30 Días: 17

Todo El Tiempo: 6,654