Tools Featured in this Teardown

Introduction

This guide will walk you through the steps to completely disassemble a Sprint Airave.

This teardown is not a repair guide. To repair your Sprint Airave SCS-26UC2, use our service manual.

Remove the external antenna, GPS cover, and GPS module.
  • Remove the external antenna, GPS cover, and GPS module.

Add Comment

Use a pry tool to remove the white outer cover. Pry towards the front of the device. Continue prying down the length of the cover until it pops off.
  • Use a pry tool to remove the white outer cover. Pry towards the front of the device. Continue prying down the length of the cover until it pops off.

Add Comment

  • Locate and remove the four Phillips screws

Add Comment

  • With the cover removed you now have access to the circuit board.

Add Comment

  • Using an 8mm socket you can remove the antenna pigtail.

Add Comment

  • Release the clip indicate to remove the circuit board.

Add Comment

  • Here is the circuit board fully removed.

Add Comment

Erik Leonard

Member since: 06/11/2011

164 Reputation

1 Guide authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 3,077