Qué necesitas
-
-
Con este tutorial vamos a limpiar las ruedas y actualizar el droide para que podamos limpiar las ruedas nuevamente en el futuro.
-
-
-
La cabeza se mantiene en su lugar mediante imanes. Las ruedas están ubicadas dentro del cabezal y recogen todo tipo de suciedad por lo que con el tiempo las ruedas se van atascando por toda la suciedad y BB-8 no responde como cuando era nuevo.
-
Pensé que podría sacar la parte inferior pero eso no es posible.
-
-
-
Utiliza una herramienta de apertura de plástico para abrir la cabeza. Se utiliza algo de pegamento, así que ten cuidado de no utilizar demasiada fuerza.
-
La parte más difícil es romper el pegamento. Una vez realizado este paso, la cabeza será mucho más fácil de desmontar en el futuro.
-
-
-
-
Vuelve a colocar la base de la cabeza en el cuerpo, esto mantendrá los imanes en su lugar.
-
-
-
Corta los remaches de plástico con una cuchilla afilada. Asegúrate de no soltar nada del plástico blanco porque se volverá a utilizar como arandela.
-
Cuando sueltes o rompas una (como yo), te mostraré cómo hacer una nueva lavadora más adelante.
-
-
-
usa un perforador y una tarjeta bancaria o SIM vieja para cortar una arandela de plástico.
-
Haz un agujero con un destornillador pequeño.
-
Un agradecimiento especial a estos traductores:
100%
¡ Francisco Javier Saiz Esteban nos está ayudando a reparar el mundo! ¿Quieres contribuir?
Empezar a traducir ›
6 comentarios
The simplist way to clean the wheels is to take a Q-Tip, dip in alcohol and clean the wheels by rotating them. I know it's not as fun as taking the head apart but...
But you can’t get the dust and hair wrapped around the axle with just a qtip and alcohol
If you want the head to stay on better, super glue some small & thin magnets to the bottom of the head. I did this and it works so well you can lift BB-8 up by his head. It also doesn't impead his speed or functionality. I also put a small piece of tape over the magnets to keep from scratching the body.
Awesome idea, could you let me know what brand/size magnet you used and what tape to recommend?
Thanks for this teardown. Now I can clean BB-8 head in case needed.
Thanks, just got a ‘tonne’ of fluff out! :-) An extra tip. Now you have it open, glue the magnets to the bottom, and you will not have to worry about them in the future. Make sure to place them in the same location you removed each from, as it will make sure the head orientation is kept correct.