Pry the phone display open by inserting a plastic opening tool into the crack that runs along the side of the phone display under the screws.
Once you have the display cover wedged open, use your fingers to pry the whole cover off the phone.
Some force may be needed to remove the cover, as several tabs are there which hold the two parts in place. Therefore, be careful when prying the cover apart
Be Extremely Careful in this next step as if you pry the hinge off too fast you may rip the connector between the logic board and screen.
Carefully wedge a plastic opening tool between the hinge on the body as shown in the highlited area in picture two. (be sure to insert the wedge into the right hinge when looking down onto the phone as in the picture).
Slowly pry the hinge off the body as shown in the third picture and set the phone down when you get to this step.
Next slide the connector cable out of the slot on the back side of the phone and the screen will be disconnected from the key pad body.