Herramientas Destacadas en este Teardown

Introducción

A teardown of the Nikon Coolpix 3500.

Este desmontaje no es una guía de reparación. Para reparar tu Nikon Coolpix 3500, utiliza nuestros manuales de servicio .

  1. Open the battery cover.
    • Open the battery cover.

    • Remove the battery.

    Agregar Comentario

  2. Remove two 4.5 mm screws next to the battery opening.
    • Remove two 4.5 mm screws next to the battery opening.

    • Remove one 3 mm screw above the CF Card opening.

    • Remove one 4.5 mm screw next to CF card opening.

    Agregar Comentario

    • Remove two 4.5 mm screws from inside the battery slot.

    Agregar Comentario

    • Remove two 5 mm screws from the opposite end of the battery.

    Agregar Comentario

    • Remove the plastic cap and newly revealed 5 mm screw.

    Agregar Comentario

  3. Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    • Remove the five identical 3.5 mm screws from the bottom of the camera.

    • Remove the grey plastic piece by gently prying the faceplate up.

    • Note: Do not pull hard, there are two wires connecting the faceplate to the logic board.

    Agregar Comentario

    • Use the spudger to lift up the white-capped wire.

    • Use a spudger to lift up the orange-capped wire at the bottom of the camera and set the faceplate aside.

    Agregar Comentario

    • Disconnect the grey-capped wire from the logic board.

    • Disconnect the blue wire attached to the green chip from the center of the logic board.

    Agregar Comentario

    • Remove the 3.5 mm screw from the logic board next to the rotating lens.

    • Invert the logic board and lens toward the orange and blue wires still connecting the logic board to the LED screen.

    Agregar Comentario

    • Disconnect the blue wire connecting the logic board to the LED screen.

    • Disconnect the orange wire using a spudger while pushing out horizontally.

    • Disconnect the red capped wire from the logic board.

    • Lift the logic board and lens (still connected) out of the back case.

    Agregar Comentario

    • Lift up on the black covering and remove the orange wire connecting the lens to the logic board.

    Agregar Comentario

    • Remove the 2.5 mm screw.

    • Remove the two 3.4 mm screws.

    • Remove the two 4.4 mm screws.

    Agregar Comentario

    • Remove the LED screen.

    • Be careful not to let the three-button rubber piece fall out while removing it.

    Agregar Comentario

Equipo

Cal Poly, Team 30-38, Garner Spring 2010 Miembro de Cal Poly, Team 30-38, Garner Spring 2010

CPSU-GARNER-S10S30G38

5 Miembros

6 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 1

Últimos 30 Días: 2

Todo El Tiempo: 7,392