Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use guitar picks to loosen clips securing rear cover and remove back cover.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Twist off 10 Phillips screws together.
-
Pry up bottom half and upper half of middle frame.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
A flexible clip is here. Loosen it and get the loudspeaker assembly only.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Release battery connector.
-
Pry up and remove battery ( Adhesive underneath is not strong).
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Loosen LCD screen connector and rear camera connector.
-
Pry up and remove motherboard assembly.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
The adhesive underneath rear camera is strong. Be careful to pry up and remove it.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Adhesive underneath vibration motor is a little bit strong. Pry it up carefully.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Tear tape securing earpiece.
-
Use tweezers to pry up earpiece.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
The sticker underneath LCD with digitizer is a little bit strong, so use heat gun to soften it for a few minutes.
-
With the help of suction cup and guitar picks, remove LCD screen carefully.
-
3 comentarios
Where is the camera's microphone placed? I replaced my camera module and now I hear noises when shooting video. May it happen because I haven't glue it back? It happens even while the phone is static, but video is fine.
I suggest that you can take it off and put some new adhesive on the backside of rear camera, and then see what happened.
Witrigs -
Um. You have a teardown that is not the iFixit official teardown, but has the same title, and links to your offsite blog/YT channel? Isn't that a bit misleading?
I think you should rename this Guide so as to not create confusion with the iFixit article with the same title. My 2¢.