Introducción

To gain access to any replaceable part, at least some of the disassembly outlined in this guide is required.

Este desmontaje no es una guía de reparación. Para reparar tu Motorola i450 Boost Mobile, utiliza nuestros manuales de servicio .

Place the phone on a flat surface with the front facing down and the antenna fully extended.
  • Place the phone on a flat surface with the front facing down and the antenna fully extended.

  • Use a spudger to remove the circular rubber cover from the base of the antenna.

  • Remove the 3.2 mm Torx T5 screw located under the rubber cover.

Agregar Comentario

Remove the antenna by grasping from the white plastic piece just below the antenna and pulling away from the phone.
  • Remove the antenna by grasping from the white plastic piece just below the antenna and pulling away from the phone.

  • Do not grasp the black antenna piece to pull it out. Doing so may damage it.

Agregar Comentario

  • Place the phone on a flat surface with the front facing down.

  • Insert your finger under the gray plastic cover at the bottom end of the phone.

  • Lift the cover off the phone.

Agregar Comentario

  • Place your thumb in the notch in the lower left corner of the battery compartment.

  • Lift the battery up and away from the phone.

  • Remove the battery.

Agregar Comentario

  • Locate the metal slider that holds the SIM card in place.

  • Push the slider away from the metal flap which contains the SIM card. The flap will pop up.

Agregar Comentario

  • Lift the metal flap to gain access to the bottom of the SIM card.

  • Remove the SIM card by sliding it out parallel to the bottom of the flap.

Agregar Comentario

  • Extend the antenna.

Agregar Comentario

  • Remove the four 4.8 mm Torx T6 screws from the corners of the back of the phone.

  • If the antenna is not fully extended, the top left screw will not be accessible.

Agregar Comentario

  • Gently lift off the back half of the phone and set to the side.

  • Permanent circuit connections prevent the cover from completely separating from the phone. Do not attempt to disconnect these circuits.

Agregar Comentario

  • Gently lift the end of the circuit board farthest from the phone hinge.

  • The circuit board is permanently connected to the phone casing at the end nearest to the hinge.

  • Grasp the keypad at the bottom of the phone, raise it, and pull it away.

Agregar Comentario

  • Exploded view of all phone components.

Agregar Comentario

Equipo

Clemson, Team 15-2, Benson Fall 2012 Miembro de Clemson, Team 15-2, Benson Fall 2012

CLEM-BENSON-F12S15G2

4 Miembros

16 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 0

Todo El Tiempo: 1,148