Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove camera&flashlight metal cover. Use tweezers to cut strong adhesives underneath.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Undo 3 screws by T4 Torx screwdriver.
-
Take away plastic securing part.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Heat up the LCD screen for a while.
-
Then with the help of suction cup, insert guitar picks to open a gap. Slide guitar picks or plastic opening tool to cut strong adhesives.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Release LCD screen connector firstly.
-
Remove LCD screen.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Undo 14 screws by T4 Torx screwdriver
-
Pry up motherboard assembly.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Release battery flex connector.
-
Separate motherboard assembly from back cover assembly.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Undo 3 screws here.
-
Use spudger to cut adhesives and pry the SIM&SD card reader board, then remove it.
-
Cancelar: No complete esta guía.
18 personas más completaron esta guía.
7 comentarios
Could you guys tell me if the main speaker, at the bottom, has a special protection agains water spills, like a membrane or so, or is it pretty fine too spill water there?
Wi fi not trun on ..moto g3
Thanks. ......................