This disassembly will show you how to remove the logic board as well as the lcd.

Este desmontaje no es una guía de reparación. Para reparar tu Motorola Defy, utiliza nuestros manuales de servicio .

Power down the phone
  • Power down the phone

Agregar Comentario

On the back there is a slider that locks the back cover on slide this over to unlock it.
  • On the back there is a slider that locks the back cover on slide this over to unlock it.

Agregar Comentario

  • Remove the battery and sim card as well as the micro sd if one.

Agregar Comentario

  • Remove the two torx screws in each corner.

Agregar Comentario

  • Remove the 3 torx screws on both sides.

  • Now remove one more torx screw on the bottom.

Agregar Comentario

  • Use the pry tool and insert in between the black and white plastic. Slide across all sides to unlock the clips holding it together.

Agregar Comentario

  • Remove the the back case (white section) revealing the logic board.

Agregar Comentario

  • Use the pry tool and detach the digitizer cable and LCD cable from the board.

Agregar Comentario

  • Lift the logic board out of the phone revealing the LCD.

Agregar Comentario

  • Use pry tool to gently lift the LCD out of the phone revealing the digitizer.

i would like to reuse LCD, does anyone know how connect and what to send to the display

lub - Contestar

  • Now all that is left is the digitizer frame holding the digitizer.

  • To remove a broken digitizer heat the front edges of this frame to soften the digitizer adhesive and pry away from the frame.

Agregar Comentario

  • Thats it now just follow these steps in reverse to put your phone back together.

CAUTION: Be sure not to touch the LCD screen or the back side of the digitizer after removing the protective plastic. If you do, you will see finger prints that you cannot remove after reassembling the phone.

Ken - Contestar


Miembro Desde 14/02/11

598 Reputación

1 Guía escrita

Brilliant! Many thanks. Things to watch: the volume rocker and on switch tend to fall out, so secured them to the back with a little bit of masking tape while I reassembled. Helped to slightly lift one end of the motherboard so the case can go around the USB power socket. After that it fits back together with only minor persuasion.

Gareth Dart - Contestar


my Search "button" stop lightning. The other 3 "buttons" are ok.

Did someone know the reason?

Thank you!

timarzoltan83 - Contestar

Thanks for help! Real great Guide.

Daniel - Contestar

Help! I bought a t5 torx screwdriver to open my motorola and the screwdriver seems too smal! Wtf? Many dismount video says that this is a t5 model, I don't understand...

Pierre Flq - Contestar

can you mark ram on that board ?

demon leaks - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 1

Últimos 30 Días: 15

Todo El Tiempo: 21,609