The Qwest Q1000 modem, made by Actiontec.

Port side with antennas detached.

DSL and Phone in ports

4 Ethernet ports

USB port, reset button, and power jack

Not a screw in sight.

As usual, the rubber feet are hiding screws!

Nothing really to see here...

Remove the 2 antenna wires from the wifi card. One is also taped to the back of the board.

The circuit board is finally free!

Looks like someone was generous with the thermal paste.

Underneath the cover:

Broadcom BCM6366

Broadcom BCM53115

The Wi-Fi card lets down its shield...

The chip is a BCM4322.

The inside of the top case.

The antenna connectors are screwed onto the case.

The antenna connectors have gold-plated coax connectors and standard Wi-Fi antenna connectors.

What's underneath the heat-shrink? A ferrite bead to minimize interference.

Testing out the light pipe with an LED throwie...

The light pipe takes light from tiny surface-mount LEDS on the motherboard and refracts it to the panel.

Here are all the LEDS:

8 of the LEDS that work with the light pipe

One more surface mount LED

A white LED for illuminating the Qwest logo

A dual-color (red/green) LED for the WPS status indicator.

The empty shell that once held a DSL modem.

The 2 detachable Wi-Fi antennas. Nothing to tear down here!

Repairability score: 8/10

The entire device is held together with only 4 screws.

The Wi-Fi antenna connectors are screwed in and the cables are not soldered to the board.

The antennas are replaceable as well.

The heat sink is soldered in place, making removal difficult.

The Wi-Fi card is soldered in and held in place with silicon adhesive, making it impossible to remove without damaging the card or the device.