A comprehensive set of repair information regarding objects with specified tasks, usually for fixing or building.

Preguntas 346 Ver todo

Sparking around the Brushes

I have a dewalt 4" angle grinder.

It started to spark on one side of the armiture.

Do you know what has happend to this tool?

Contestado! View the answer Yo también tengo este problema

Es esta una buena pregunta?

Calificación 1

Comentarios:

i have a HOYOMA 3263T rotary hammer the carbon brushes are burning w/ smoke what happen on this tool?

por

I hav an angle cutter of KPT now its sparking a lot and it become heat could not hold and smoke is comes out from the inside.

por

dasbishu1986 sounds like a shortened out motor windings. You can take it apart and see if you find some burn marks etc. but you most likely you will need to find a replacement.

por

Agregar un comentario

2 Respuestas

Solución Elegida

If the sparks go all the way around the copper strips, also called the commutator, the armature has shorted. That means the insulation between the wires and the iron has broken down in the inside of the armature. Some times it can be as simple as a short between the bars, the copper strips, of the commutator.

With the tool unpluged, use an air hose with an air nozzle to blow any trash or dust from the area around the brushes and the communator.

If that does not improve the symptoms the next thing is, with the tool unpluged, remove the brushes, often a screw on cap hold them in, and inspect and compare the length. A short length will cause the springs to not put enough pressure on the carbon to make good contact with communtator. In that case, replace the brushes. Also check the freedom of movement of the brushes. If dirt jams the channel the brush slides in, the spring can't push the carbon tight to the commutator.

Good luck!

This repair will work on other hand-held power tools.

Fue útil esta respuesta?

Calificación 9

Comentarios:

Should the screw on cap be tight or slightly loose on the brushes

por

Agregar un comentario

May need to ensure zero debris between commutation segments and to use a sharp blade to cut away said debris.

Fue útil esta respuesta?

Calificación 0

Comentarios:

Working but the corbon bursh is burning

por

How to remove the short

por

Agregar un comentario

Añadir tu respuesta

James Hartman estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 Horas: 52

Últimos 7 Días: 411

Últimos 30 Días: 1,897

Todo El Tiempo: 42,845