Repair and support for the third generation of the Flip portable speaker by JBL.

Preguntas 34 Ver todo

Little part fell off the JBL flip 3 motherboard labeled 1R5

I dropped my JBL flip 3 speaker the other day and I started to hear a rattle inside so I decided to take it apart and see what it was and it was a small box at the top Corner of the motherboard labeled 1R5 and i don't know how to put it back on

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Calificación 1

Comentarios:

Exact same problem has happened to me, does anyone have a solution

por

the same excact thing happened to me

por

Agregar un comentario
MacBook Battery Fix Kits
Fix Kits Starting at $69.99
MacBook Battery Fix Kits
Starting at $69.99

2 Respuestas

@mtz13 without actually seeing what is going on, it is difficult to answer. Consider posting some picture of your board with your question. Use this guide Adding images to an existing question for that. The 1R5 sounds like a fixed 1.5uH inductor. Again without seeing it, this is only an assumption. Those are usually soldered to the board and there is not other way reattach it.

Fue útil esta respuesta?

Calificación 0
Agregar un comentario

Something similar happened to me. The 1R5 piece didn't break down fully and now one contact is lose. I think the only way is to solder it down. https://imgur.com/a/2y4Xy

Fue útil esta respuesta?

Calificación 0
Agregar un comentario

Añadir tu respuesta

Joe estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 Horas: 1

Últimos 7 Días: 6

Últimos 30 Días: 41

Todo El Tiempo: 420