Repara tus cosas Comunidad Tienda

The Mavic Pro is a foldable, compact drone with 4K video capabilities, first released in November 2016. The model number is M1P and its controller model is GL200A.

Preguntas 41 Ver todo

Opciones

camera has water inside

hi there,

i was flying sideways and drowned my mavic pro in a tree which fall then in a river (sweet water). Found it again 24 hours later in about 4 meters under water -

everything works fine but it got water inside the camera which is now stuck on the glass in front of the lens and obviously can not disappear by itself. I opend the little screws but did not dare to go further as the parts did not want to get loose. I also see a golden ring near the lens cover which could hold it in place...?

any help?

Thanks anyway!

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Sí No
Puntuación 1
Agregar un comentario

1 Respuesta

Filtrar por:
Mas Útiles Más Reciente Más antiguo
Respuesta Más Útil

Opciones

Do not charge it! Follow these guides to clean all the parts to help prevent water from corroding it. Do it ASAP!

Read this: Electronics Water Damage

Disassembly: DJI Mavic Pro Teardown

Proper cleaning demonstration: Reparación de los daños en un iPhone debido a la entrada de líquidos

As for the camera, there is no hope. You'll need to replace it. Use the teardown to replace it and any other non-functioning part. I recommend taking it low and easy the first few flights to make sure everything's working.

Hope this helps!

Imagen de iPhone

Guía

Reparación de los daños en un iPhone debido a la entrada de líquidos

Dificultad:

Difícil

—

1 - 2 hours
Imagen de DJI Mavic Pro

Guía

DJI Mavic Pro Teardown

Dificultad:

Moderado

Fue útil esta respuesta?

Sí No
Puntuación 3

3 comentarios:

In that case that the camera can not be opened I try to remove the glass and find something to replace it (because the camera is working fine, it is only a waterdrop behind the glass which is in the view,..), if i kill it i have to excange it anyway...

Thank you!

- de

actually maybe just exchange open the glas, release the moisture and put on a ND filterlens would solve the problem :)

- de

Jeronimo I do not recommend that. You should replace it. 24Hr underwater also penetrated the sensor, which you can not fix. Have you cleaned the drone using the instructions above? This is something you should have done days ago. If you haven't done it yet, then the corrosion has probably already caused irreversible damage.

- de

Agregar un comentario

Añadir tu respuesta

jeronimo estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 8

Ultimos 30 días: 16

Todo El Tiempo: 1,674