Kenmore Frigidaire Dryer Drum light on but controls not working

I have replaced the control board (137237100) on my Kenmore Frigidaire Dryer model 417.81102000 three times. Each time it lasts for about 2 years and it goes bad again. Could there be another part on this unit that is causing it to fail where I should change them both? Could the control board be experiencing too much heat and it fails over time? Are there any known issues with this control board?

After replacing, the unit works perfectly. Then after about 1.5 to 2 years on average, some of the user controls seem to work intermittently until a total failure occurs. The unit is still receiving power because the drum light still works. During the intermittent failures, I can power the unit off an on again to get it to work. This can be done for 3- 6 months before it fails for good.

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 0
Agregar un comentario