The Apple iPhone 5c was announced on September 10, 2013. Repair of this device is similar to the previous models, and requires screwdrivers and prying tools. Available as GSM or CDMA / 8, 16, 32 GB / White, Pink, Yellow, Blue, and Green.

Preguntas 1480 Ver todo

How can I fix a keyboard problem?

iPhone 5C keyboard will not type certain letters after screen repair. Everything else works fine except for the keyboard. It wont allow me to use the numbers button. Tried a hard reset. Did not work. What can i do?

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Calificación 12
Agregar un comentario

6 Respuestas

Respuesta Más Útil

Sounds like a faulty digitizer to me, or a poorly seated digitizer connector. Did you do the screen repair yourself, or did you have a repair shop do it?

Fue útil esta respuesta?

Calificación 4

Comentarios:

My sreen is smashed but this was happening before i

Smashed it

por

no it was not

por

I had the repair shop to do it.

por

You should tell your shop about it. If a different "known good screen" does the same (a whole batch can be bad), then the issue can be with a chip on the board that controls touch. It would be partially separated from the board, causing some areas of the screen to become unresponsive. But really must try a new known good screen first.

por

Agregar un comentario

If a different "known good screen" does the same (a whole batch can be bad), then the issue can be with a chip on the board that controls touch. It would be partially separated from the board, causing some areas of the screen to become unresponsive.

But really must try a new known good screen first, as this is still the first suspect.

Fue útil esta respuesta?

Calificación 4
Agregar un comentario

Usually, the problem occurs after a screen has been replaced and the digitizer cable has not been seated properly. You have to ensure the correct sized screws fitted into the correct position. There are four screws holding down the shield that covers the display cables and if you mix them up then your shield and cover will not fit correctly and the cable connectors will move and cause digitizer and screen faults. Uisung #000 screwdriver you can easily remove and refit these screws, if you are unsure the bottom two are the smallest (1.3 mm screws) and then the upper left is slightly larger (1.7 mm screw) and the far right screw is the largest of them all (3.25 mm screw). You can prior to the removal use a coloured marker or pen and colour code the screws to the position they belong to, remember the two lowest screws (1.3 mm screws) are the same size so can be coloured the same. This should help resolve any problems with exchanged screens and cabling to screen faults. Thanks guys

Fue útil esta respuesta?

Calificación 2
Agregar un comentario

hello,

this is in relation with touchscreen ic chip when everything is all right...

Fue útil esta respuesta?

Calificación 1
Agregar un comentario

My keyboard is frozen also screen

Fue útil esta respuesta?

Calificación 1
Agregar un comentario

my iPhone 5s I got the screen repaired and the u and n dose not work on the keybord

Fue útil esta respuesta?

Calificación 0
Agregar un comentario

Añadir tu respuesta

keldavis5 estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 Horas: 27

Últimos 7 Días: 157

Últimos 30 Días: 741

Todo El Tiempo: 25,542